Short answer: Usually the more fouling, corrosive, high-pressure or toxic fluid goes in the tubes; cooling water goes in the tubes; viscous and condensing fluids usually on the shell side.
Why
Tubes are easier to clean mechanically, cheaper to make from alloy (only tubes and channels, not the whole shell), and hold pressure better because of their small diameter.
How
- Tube side: cooling water, high-pressure gas, corrosive acids, fouling crude.
- Shell side: condensing steam or vapours, viscous oils (baffles create turbulence at low Re), low ΔP allowed fluids.
- Check velocity 1–2.5 m/s in tubes to limit fouling.
What you learn only in industry
Crude preheat trains foul badly; plants track the drop in U and schedule hydro-jetting during turnarounds. Antifoulant injection is a common optimisation project.
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL, NPCIL, BARC. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
Which fluid goes on the tube side of a shell-and-tube exchanger, and why?
Usually the more fouling, corrosive, high-pressure or toxic fluid goes in the tubes; cooling water goes in the tubes; viscous and condensing fluids usually on the shell side. Why: Tubes are easier to clean mechanically, cheaper to make from alloy (only tubes and channels, not the whole shell), and hold pressure better because of their small diameter.
Related questions
- Why is counter-current flow preferred in heat exchangers?
- What is fouling? How does it affect a heat exchanger and how is it controlled?
- What is the difference between fixed tube sheet, U-tube and floating-head exchangers?
- Why is steam used as a heating medium? Why saturated rather than superheated steam?
- What is a steam trap? Name the types.
- Explain the working of a fired heater (furnace) in a refinery.