Short answer: Corrosion is chemical/electrochemical attack of metal; erosion is mechanical wear by high-velocity fluid, droplets or particles, worst at elbows, tees and downstream of control valves. Erosion–corrosion combines both.
Why
High velocity removes protective oxide films and impacts the wall.
How
- Limit velocity; use long-radius bends and target tees.
- Harder or alloy materials, ceramic or hard-faced linings.
- Inhibitors, pH control, coatings and cathodic protection for corrosion.
- Thickness monitoring (UT) at marked points; replace thin spools in turnarounds.
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL, NFL, RCF, BVFCL, NPCIL, Heavy Water Board. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
What is erosion in pipes and how is it different from corrosion? How are both controlled?
Corrosion is chemical/electrochemical attack of metal; erosion is mechanical wear by high-velocity fluid, droplets or particles, worst at elbows, tees and downstream of control valves. Erosion–corrosion combines both. Why: High velocity removes protective oxide films and impacts the wall.
Related questions
- How do you know whether a gate valve, a globe valve or a butterfly valve is open or closed?
- What is an NRV (non-return valve)? Where is it fitted on a pump and why?
- Why is the discharge isolation (gate) valve placed after the NRV on a pump?
- What does “crack open” a valve mean?
- What are LO, LC, CSO, CSC (always-open and always-closed) valves?
- What is a pneumatic control valve? What do air-to-open and air-to-close mean?