Short answer: Opening a valve just slightly (a few turns or a fraction of travel) so that a small flow passes.
Why
Used to warm up lines, equalise pressure, purge, fill slowly, or start a pump against nearly closed discharge without water hammer.
How
- Steam lines: crack open to warm up with drains open.
- Before opening a big valve under ΔP: crack open the bypass to equalise.
- Then open fully in steps while watching pressure and noise.
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL, NFL, RCF, BVFCL, NPCIL, Heavy Water Board. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
What does “crack open” a valve mean?
Opening a valve just slightly (a few turns or a fraction of travel) so that a small flow passes. Why: Used to warm up lines, equalise pressure, purge, fill slowly, or start a pump against nearly closed discharge without water hammer.
Related questions
- How do you know whether a gate valve, a globe valve or a butterfly valve is open or closed?
- What is an NRV (non-return valve)? Where is it fitted on a pump and why?
- Why is the discharge isolation (gate) valve placed after the NRV on a pump?
- What are LO, LC, CSO, CSC (always-open and always-closed) valves?
- What is a pneumatic control valve? What do air-to-open and air-to-close mean?
- What is a solenoid valve and how does it open?