Short answer: High-point vents release air or gas when filling and allow venting during depressurising; low-point drains remove liquid for hydrotests, start-up, maintenance and condensate removal.
Why
Trapped air causes water hammer and wrong readings; trapped liquid causes corrosion, freezing and contamination.
How
- Vents and drains on hydrocarbon service go to closed systems (flare, closed drain), not open air.
- They are plugged or capped when not in use (double block for hazardous service).
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL, NFL, RCF, BVFCL, NPCIL, Heavy Water Board. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
What are vents and drains on lines and equipment for?
High-point vents release air or gas when filling and allow venting during depressurising; low-point drains remove liquid for hydrotests, start-up, maintenance and condensate removal. Why: Trapped air causes water hammer and wrong readings; trapped liquid causes corrosion, freezing and contamination.
Related questions
- How do you know whether a gate valve, a globe valve or a butterfly valve is open or closed?
- What is an NRV (non-return valve)? Where is it fitted on a pump and why?
- Why is the discharge isolation (gate) valve placed after the NRV on a pump?
- What does “crack open” a valve mean?
- What are LO, LC, CSO, CSC (always-open and always-closed) valves?
- What is a pneumatic control valve? What do air-to-open and air-to-close mean?