Short answer: A centrifugal pump develops head in proportion to fluid density; with air in the casing it cannot create enough suction to lift liquid. A positive-displacement pump physically displaces whatever is in the cylinder and can draw liquid up.
Why
Head H = u²/g roughly depends on impeller speed, not density, so the pressure rise ΔP = ρgH is about 800 times smaller for air than water — too little to pull liquid into the suction line.
How
- Fill the casing and suction line with liquid through the priming funnel or by flooded suction.
- Vent air from the top of the casing.
- Self-priming pumps keep a liquid reserve in the casing; vacuum-assisted priming is used for large pumps.
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
Why do we prime a centrifugal pump but not a reciprocating pump?
A centrifugal pump develops head in proportion to fluid density; with air in the casing it cannot create enough suction to lift liquid. A positive-displacement pump physically displaces whatever is in the cylinder and can draw liquid up. Why: Head H = u²/g roughly depends on impeller speed, not density, so the pressure rise ΔP = ρgH is about 800 times smaller for air than water — too little to pull liquid into the suction line.
Related questions
- What is NPSH? What is the difference between NPSH available and NPSH required?
- Why is a centrifugal pump started with the discharge valve closed (or slightly open)?
- How do you choose between a centrifugal and a positive-displacement pump?
- What are the pump affinity laws? Why are they useful?
- What happens when two identical centrifugal pumps are run in parallel and in series?
- What is water hammer? How is it prevented?