Short answer: Non-contacting mechanical seals in which a thin film of filtered gas separates rotating and stationary faces; they replaced oil-film seals in most modern compressors.
Why
They leak very little process gas, need no seal-oil system and have low friction.
How
- Clean, dry seal gas is supplied by a filtration panel; primary leakage goes to flare.
- Separation gas (nitrogen or air) keeps bearing oil away from the seals.
- Liquid or dirt in seal gas destroys seals — keep seal gas above its dew point.
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL, NFL, RCF, BVFCL, NPCIL, Heavy Water Board. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
What are dry gas seals in centrifugal compressors?
Non-contacting mechanical seals in which a thin film of filtered gas separates rotating and stationary faces; they replaced oil-film seals in most modern compressors. Why: They leak very little process gas, need no seal-oil system and have low friction.
Related questions
- What is NPSH? What is the difference between NPSH available and NPSH required?
- Why is a centrifugal pump started with the discharge valve closed (or slightly open)?
- Why do we prime a centrifugal pump but not a reciprocating pump?
- How do you choose between a centrifugal and a positive-displacement pump?
- What are the pump affinity laws? Why are they useful?
- What happens when two identical centrifugal pumps are run in parallel and in series?