Short answer: Orifice and venturi infer flow from ΔP (Q ∝ √ΔP); rotameters by float position; magnetic meters from induced voltage in conducting liquids; Coriolis meters measure mass flow directly from tube twist.
Why
Bernoulli: accelerating fluid through a restriction lowers pressure; the drop gives velocity. Coriolis force on a vibrating tube is proportional to mass flow, independent of density and viscosity.
How
- Orifice: cheap, high permanent loss, needs straight run (10–30 D upstream), range ~3:1.
- Venturi: low loss, expensive, used for large water lines.
- Magnetic: no obstruction, liquids with conductivity >5 µS/cm, slurries.
- Coriolis: custody transfer of products, high accuracy (0.1 %).
- Vortex, ultrasonic and turbine meters for steam, gas and clean liquids.
What you learn only in industry
Custody transfer of crude and products to tankers and pipelines uses metering skids with prover loops; a 0.1 % error on a big refinery is crores per year.
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL, NPCIL. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
How is flow measured in a plant? Compare orifice, venturi, rotameter, magnetic and Coriolis meters.
Orifice and venturi infer flow from ΔP (Q ∝ √ΔP); rotameters by float position; magnetic meters from induced voltage in conducting liquids; Coriolis meters measure mass flow directly from tube twist. Why: Bernoulli: accelerating fluid through a restriction lowers pressure; the drop gives velocity. Coriolis force on a vibrating tube is proportional to mass flow, independent of density and viscosity.
Related questions
- What is NPSH? What is the difference between NPSH available and NPSH required?
- Why is a centrifugal pump started with the discharge valve closed (or slightly open)?
- Why do we prime a centrifugal pump but not a reciprocating pump?
- How do you choose between a centrifugal and a positive-displacement pump?
- What are the pump affinity laws? Why are they useful?
- What happens when two identical centrifugal pumps are run in parallel and in series?