Short answer: Check, prime, open suction, start against a closed (or cracked) discharge, then open the discharge slowly while watching pressure and current.
Why
This protects the motor from overload, avoids cavitation and dry running, and prevents water hammer.
How
- Pre-checks: permit closed, coupling guard fitted, lube oil level, seal flush/quench on, cooling water to bearings, motor isolator in “on”.
- Open suction valve fully; vent casing until liquid comes out (prime).
- Ensure discharge valve closed or cracked; minimum-flow line open if provided.
- Start; check discharge pressure builds to shut-off pressure and ammeter reading falls after starting peak.
- Open discharge gradually; check flow, vibration, noise, leakage, bearing temperature.
What you learn only in industry
Never run a pump with suction closed — it overheats in minutes and the seal fails. Many incidents start with a pump started on the wrong line-up.
Likely focus at
IOCL, HPCL, BPCL, NRL, MRPL, CPCL, ONGC, Oil India, GAIL, BCPL, EIL, NFL, RCF, BVFCL, NPCIL, Heavy Water Board. Organisation names show where a topic is a likely focus because of what the organisation does; they are not claims that a particular question was asked. Recruitment routes change each year, so confirm in the official notification.
Frequently asked questions
How do you start a centrifugal pump from standby? Give the procedure.
Check, prime, open suction, start against a closed (or cracked) discharge, then open the discharge slowly while watching pressure and current. Why: This protects the motor from overload, avoids cavitation and dry running, and prevents water hammer.
Related questions
- What is NPSH? What is the difference between NPSH available and NPSH required?
- Why is a centrifugal pump started with the discharge valve closed (or slightly open)?
- Why do we prime a centrifugal pump but not a reciprocating pump?
- How do you choose between a centrifugal and a positive-displacement pump?
- What are the pump affinity laws? Why are they useful?
- What happens when two identical centrifugal pumps are run in parallel and in series?